The Simplex Master Dies are precision reamed and heat treated to last a lifetime. The interior of the dies is hand polished while the exterior is the standard 7/8" x 14 thread and will fit any press using this standard.
SERIES 1 AND 2
FOR BOTTLENECK RIFLE AND PISTOL CARTRIDGES.
Available in full length resizing 2 Die Set (FLS Die and Seating Die)
or 3 Die Set (FLS Die, Seating Die) and Neck resizing Die)
NECK RESIZING DIES
With neck resizing dies the accuracy conscious reloader can retain the fire formed dimensions of their case and only resize the neck area.
Available in all Series 1 and 2 Calibres.
SERIES 3 AND 4
STRAIGHT WALL RIFLE AND PISTOL CARTRIDGES
Complete with shell holder and priming post.
Super Simplex dies reload Straight Wall cases in three operations.
Firstly the case is neck resized and decapped.
The second operation mouth expands the case with the stepped mouth expander die insuch a way as to accept cast or jacketed bullets without tipping or shaving.
In the third operation the bullet seating die can be set to roll crimp.
CARBIDE DIE SETS
A must for the serious hand gun reloader. The carbide full length sizing die eliminates the need for case lubrication, reduces sizing effort and last a lifetime.
Available in a 3 Die Set or the Carbide Full length Sizing Die can be purchased seperately.
STEPPED EXPANDER DIES
The Stepped Expander Die was designed for cast bullet loading of straight wall rifle and pistol cartridges but is now available for bottle neck rifle cartridges.
It prevents bullet tipping and eliminates the need for excessive case mouth flaring.
Available in all Series 1 and 2 Calibres
COLLET TYPE BULLET PULLER
Occasionally the reloader will need to pull bullets from reloads because of a problem or because standard ammunition requires alteration.
The Simplex Bullet Puller will grip any length or shape bullet without damage and hold tightly as the case is pulled away.
Precision collets are available in .17 to .45 calibre.
SIMPLEX MASTER FORMING DIES
Case forming dies are for those who wish to form brass cases from one calibre to another. Most case forming is done to produce ammunition that is not factory available. Case forming dies are designed to change the shape of the original parent case in small increments to avoid overworking the brass and to prolong case life. After using the proper form dies and/or Form & Trim Die, full length resizing is required..
NOTE: Full length resizing is a necessary final operation after all case forming to insure proper chambering.
.17 Ackley Hornet from .22 Hornet Cases
.17-222 from .222 Remington Cases
.17 Mach IV from .221 Remington Fireball Cases
.17 Ackley Bee from 218 Bee Cases
.22 - 303 from .303 British Cases
.22 Reminington Magnum from 5.6 x 50 RWS Cases
.222 Rimmed from 5.6 x 50R RWS Cases
.25-06 from .30-06 Cases
.270-.308 from .308 Winchester Cases
.35 Whelen from 30.06 Cases
.416 Remington Magnum from .375 H&H Cases
.25.308 (25super) from 308 Cases
303.270 (no form die is needed use 303.270 FLS Die) from 303 British Cases
303.25 from 303 British Cases
303.243 (need to uses 303.25 Form Die then 303.22 Form Die then 303.243 FLS Die) from 303 British Cases
303.22 (need to uses 303.25 Form Die then 303.22 Form Die then
303.22 FLS Die) from 303 British Cases
SM TAPER CRIMP DIES
Available in certain pistol Calibres
check for avalability